MIOSHA: Session 13 & 14

According to Part 22 of the Safety Standards, what is the minimum permissible height for a saw-horse type barricade that will be used to direct traffic?

Which type of exposure to asbestos fibers is considered the most hazardous to your health?

Which of the brick patterns is called a Stack Bond?

When using an extension ladder, what is the last rung you may stand on according to MIOSHA standards?

In order to comply with MIOSHA, all power cords must be

You have been awarded a project to restore a historical home. Part of the restoration requires painting and acid will be used to prepare and clean the surface. What must you as the contractor provide to your employees for protection on the job?

Scaffold planking should overlap other planks by

MIOSHA rules state that the maximum permissible height for ladder jack scaffolds is?

Select the best term for the following definition. What is used to carry the weight of masonry units over a door or window?

MIOSHA rules dictate the minimum distance between power lines and a portable non-metallic ladder. What is the minimum distance allowed?

What type of tie is used to attach masonry to other masonry structures?

MIOSHA rules state a ladder must extend what minimum distance above the upper landing surface?

A brick veneer wall should be constructed

According to OSHA, what is the minimum distance between power lines and a portable non-metallic ladder?

As the safety officer for a project, you are responsible for making sure all MIOSHA rules are complied with. A tubular steel scaffold must have a guardrail if it is above what minimum height?

What is the top stone of an archway called?

A hole is defined as a gap or void in a walking-working surface of at least

As a general contractor, MIOSHA rules state you do not need to supply which of the following to an employee?

Select the correct answer from the choices below. What is the definition of a brick laid across two wythes of masonry?

Who shall provide, install, and maintain signals, signs, barricades, and tags, where an employee might be, or would likely be, injured if not alerted to the hazard?

The amount of overlap for a ladder up to and including 32 feet is

What type of joint is shown by figure #1 on the side of the masonry cross section?

Why are toe boards used on a scaffold?

From the list below, select the material that has the greatest chance of shifting during excavation.

What type of joint is shown by figure #3 on the side of the masonry cross section?

Which piece of personal protective equipment is an employee responsible for providing?

In reference to fall protection, a height above ______ requires fall protection.

What type of joint is shown by figure #5 on the side of the masonry cross section?

Containers and drums without labeling should be considered?

In reference to scaffolds, planking should overlap at least

What type of joint is shown by figure #4 on the side of the masonry cross section?

Which does NOT require the use of safety glasses?

In reference to scaffolds, planking should overlap at least

What type of joint is shown by figure #6 on the side of the masonry cross section?

What minimum size planking can be used for scaffolds?

Toe boards should be located

What type of joint is shown by figure #7 on the side of the masonry cross section?

MIOSHA defines a “hole” as a gap or void in a work surface with the least dimension of

From the list below, select the piece of safety equipment that is not used for handling insulation.

Which of the brick patterns is called a Flemish Bond?

Where is it permissible to use shore or lean-to scaffolding?

What is the maximum fine for giving MIOSHA false information?

Which of the brick patterns is called a Running Bond?